18 To Raise Or Lower Main Boom Using Platform Control Console; 19 To Sound Horn; 20 To Rotate Turret Using Platform Control Console; 21 To Operate Using Emergency Power Switch At Platform Control Console - Skyjack SJ 46A Operating Manual

Articulating boom series (ansi/csa)
Table of Contents

Advertisement

Start Operation
2.10-18 To Raise or Lower Main Boom Using
Platform Control Console
1.
Depress and hold footswitch.
2.
Push and hold boom/turret controller in this
direction "
" to raise main boom or "
to lower main boom.
3.
Release controller handle to stop.

2.10-19 To Sound Horn

1.
Press "
" horn pushbutton to sound horn.
Release pushbutton to stop sounding horn.
2.10-20 To Rotate Turret Using Platform
Control Console
wARNiNG
When rotating the turret, ensure that there
are no personnel or obstructions in the
path of rotation, including blind spots.
1.
Depress and hold footswitch.
2.
Push and hold boom/turret controller in this
direction "
" to rotate clockwise or "
rotate counterclockwise.
3.
Release controller handle to stop.
NOTE
Turret
can
be
360 degrees.
TM
Page 48
" to
rotated
continuously
December 2007
2.10-21 To Operate Using Emergency Power
Switch at Platform Control Console
This is a momentary-type switch. This switch allows all
functions except drive function to operate in the event
of engine malfunction. Refer to
emergency lowering procedure.
"
The emergency power unit has two-minute
Do not use emergency power unit
c o n t i n u o u s l y f o r m o r e t h a n t w o

2.10-22 Shutdown Procedure

1.
Completely retract boom and lower platform.
Ensure that you maintain three points of
contact to mount/dismount the platform.
2.
Push in "
" emergency stop button on platform
control console and on base control console.
3.
Turn base/off/platform key switch to "
position. Remove key.
4.
Turn main power disconnect switch to "
position.
For aerial platform with cold weather start option:
When temperature gets below -11°C
(+11°F), ensure aerial platform is parked
close to AC outlet.
5.
Plug in battery warmer/hydraulic oil heater into
AC outlet at least 4 hours before starting engine.
Section 2 - Operation
Section 2.14
NOTE
duty cycle.
CAUTiON
minutes.
wARNiNG
NOTE
SJ 46A & SJ 46AJ
for the
" off
" off

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sj 46aj

Table of Contents