Monitor Rear View; Figure 4. Rear View Of Monitor; Table 4. Rear View Features And Descriptions - Nonin LifeSense LS1-9R Operator's Manual

Monitor Rear View

The moisture trap, filter, and equipment label are located on the back of the LifeSense (figure 4).
Names and descriptions of each component are listed in table 4.
2
4
No. Name
Single-Use,
1.
Disposable
Moisture Trap
with Filter
Attachment
2.
Holes
Luer Lock
3.
Equipment
4.
Label
14
Figure 4: Rear View of Monitor
Table 4: Rear View Features and Descriptions
The filter is a single-use disposable component and should be replaced
after each patient use or cleaning. It fits into the moisture trap and
protects the monitor from moisture. The moisture trap clicks into position
from the left hand side of the monitor.
When the moisture trap is removed, guide marks (numbered 1 and 2) and
arrows are visible on the back of the monitor. These guide marks help the
user insert the moisture trap.
1. Slide the moisture trap into position.
2. Press it down. Push tab out to remove.
Dedicated holes for attaching a mounting bracket. See "Accessories" if a
mounting bracket is required. 2 mm screws can be used if there is a need
to attach the monitor in a fixed position.
Luer lock connector for attaching sample line, Nafion tubing, or cannula.
The label contains the model number, serial number, manufacturing date,
manufacturer, UL mark, and other applicable symbols. See the "Guide to
Symbols" section for descriptions of the different symbols.
Every LifeSense device has a unique serial number for identification.
Description
3
1