Using The Lifesense Monitor; Stationary Operation; Battery Operation - Nonin LifeSense LS1-9R Operator's Manual

Using the LifeSense Monitor

After unpacking the monitor and accessories, LifeSense is ready for use. Ensure the LifeSense
battery is fully charged by viewing the status of the battery indicator on the display panel after
the power supply is connected to the monitor and the power outlet.
CAUTION: To prevent damage to the monitor, operate and store the monitor in an
!
upright position.

Stationary Operation

1. Place the monitor in a position so the display can be clearly seen.
2. Connect the power supply to the monitor and to a power outlet. The green indicator
on the front panel will light up as soon as the monitor is connected to the outlet.
3. Turn LifeSense monitor on by pressing the ON/OFF
WARNING: Prior to connecting LifeSense to the power supply and the power outlet,
be sure to verify the voltage and frequency rating on the power supply are the same
as the power outlet. If this is not the case, do not connect the monitor and power
supply to the outlet.
WARNING: When turning on the monitor, verify that a beep is heard each time a
button is pressed. If a beep is not heard, do not use the device. The speaker may not
be functioning properly.

Battery Operation

CAUTION: Before first use and before storing this monitor, fully charge battery.
!
CAUTION: If not continuous use, fully charge battery at six-month intervals.
!
Whenever the monitor is to be used portably or in an environment where there is no power, it
can operate on battery power. This is only possible if the battery has been charged. Always plug
in the power supply as soon as it is possible for the monitor to be connected to a power outlet.
1. Place the monitor in a position so the display can be clearly seen.
2. Turn LifeSense monitor on by pressing the ON/OFF
battery symbol on the touch panel display shows the battery capacity.
3. Plug the LifeSense power supply into the power outlet as soon as there is no need for
battery operation.
WARNING: LifeSense displays a BATT LOW message when it has approximately
20 minutes of use remaining before it shuts itself off.
16
button until you hear a beep.
button until you hear a beep. The