System Setup; X-100H Hub; Connect/Disconnect The Hub To The Monitor; X-100Hh Hub Holster - Nonin SenSmart X-100 Service Training

Key Component
F
SenSmart Sensors
Power supply and cord
(not shown)
SenSmart Download
Software (CD not
shown)

System Setup

This section describes the features of the SenSmart components and how to connect the
components to prepare for patient monitoring.

X-100H Hub

•
The Hub and cable connects to the port on the front of the
Monitor and provides connections for up to six Signal Processors
using the Hub ports. See Figure 2.
•
The Hub ports are protected from environmental contamination
with covers that are opened to connect a Signal Processor. If the
Hub port is not being used, the cover should remain closed to
eliminate the potential for environmental contamination.

Connect/Disconnect the Hub to the Monitor

1. To connect:
a. Align the arrow on the Hub cable connector with the
small triangle on the Monitor connector port.
b. Push the Hub cable connector straight into the port
until it clicks and locks into place.
2. To disconnect:
a. Grasp the sleeve on the Hub cable connector.
b. Retract the sleeve to unlock, and pull the Hub cable
connector straight back to detach from the Monitor as
shown in Figure 3.

X-100HH Hub Holster

The Hub can be placed in the Hub Holster to stabilize the Hub when attaching it to bed linens, bed
rail, or a pole by using the clamp on the back of the Hub Holster.
1. To place the Hub in to the Hub Holster
a. Align the Hub and hub cable to the Hub Holster as shown in Figure 4A. Push firmly
into the Hub Holster.
b. Attach to bed linens, bed rail, or a pole using the clip as shown in Figure 4B.
SenSmart™ Model X-100 Universal Oximetry System
 Available to measure rSO
2
 Sensors are described in more detail in the SenSmart Sensor section on page 7.
Data management software
5 of 31
Description
and SpO .
2
Figure 2. SenSmart Hub with port covers.
Figure 3. Align the arrows and push the
Hub cable connector into the Monitor port.
In-Service Training