Airbox Pressure Sensor; 1) Water Trap - Rotax 914 F Installation Manual

17.2) Airbox pressure sensor

See Ill. 47.
effective range:
deviation:
operating temperature: min.
dimensions and attachment:
fitting position:
The pressure connection (Pos. E Ill. 47) points downwards to prevent possible
condensate from entering the sensor, i.e. the longitudinal axis z4 has to be parallel
to z-axis in system of coordinates.
tolerated deviation of parallelism ± 60°
location of installation:
vibration neutralized installation
ATTENTION: The pressure connection has to be protected against entering of
NOTE:
length of cable assy.: approx. 250 mm (10 in) from TCU.

17.2.1) Water trap

See Ill. 48/49.
Water trap is included in the supply volume of the engine.
2
1
Ill. 48
Modification-No.
- 0 -
500 ÷ 2500 hPa
max. ± 60 hPa
max.
foreign matter e.g. oil, fuel, water etc. (see chapter 17.2.1).
Location of installation is limited by the length of the wiring harness.
dimensions and attachment: see sketch (Ill. 49)
location of installation:
The water trap Q has to be installed by clamps free of stress between
hose W 4x7 of airbox and the airbox pressure sensor E.
ATTENTION: Utilize full slip-on length on all connections.
3
Reference
- 40° C (- 40° F)
+125° C (257° F)
see sketch (Ill. 47)
Install
914 F
ø35
ø6
ø6
Ill. 49
ø30
Date
1996 05 10
Page
69