Connecting Dimensions And Location Of Connections; 1) Oil Circuit (Engine); 2) Oil Circuit (Turbo Charger) - Rotax 914 F Installation Manual

13.4) Connecting dimensions and location of connections

ATTENTION: Utilize the full slip-on length for hose connections. Secure hoses with

13.4.1) Oil circuit (engine)

See ill. 24/25.
Oil pump (inlet) Q ................... thread M18 x 1,5 x 11
1
Oil return
According to propeller configuration choose the appropriate connection for
the oil return line.
Position 1 for tractor or 2 for pusher configuration. See ill. 28.
hose nipple W .......................... 10 DIN 7642
outside dia. ............................... 12 mm
slip-on length ............................ max. 24 mm
2
pos. 2
Druckpropeller
(pusher config.)

13.4.2) Oil circuit (turbo charger)

See ill. 26.
Oil return
hose nipple R ......................... 4/6 DIN 7642
outside dia. ............................... 8 mm
slip-on length ............................ max. 20 mm
4
Modification-No.
- 0 -
suitable screw clamp or by crimp connection.
3
pos. 1
Zugpropeller
(tractor config.)
5
Reference
NOTE:
Suitable for use of a swivel joint. See ill. 28.
Tightening torque 25 Nm (220 in.lb)
Ill. 24
Tightening torque of banjo bolt E
M16x1,5x28: 35 Nm (310 in.lb).
Ill. 25
Tightening torque of banjo bolt T
M10x1x19: 17 Nm (150 in.lb)
Ill. 26
Install
914 F
(0,5 in.)
(max. 0,94 in.)
(0,31 in.)
(0,79 in.)
Date
Page
1996 05 10
43