Change And Adjustment Of Buckle Feeding Bed - Siruba ASP-BST100 Instruction Book And Parts List

3. 扣環供給底板①的交換及調整
⑴將螺絲②轉開，交換扣環供給底板①。
⑵當扣環供給底板①移至最右邊時，溝③的
中心線④與八字扣固定器的中心線⑥保持
一致。
【調整】轉鬆自鎖螺帽⑦，以轉動氣壓缸
桿⑧來調整。
⑶當扣環供給底板①移動至最右邊時，扣環
供給底板①與八字扣固定器⑤之間的縫隙
為 0.5mm。
【調整】將螺絲⑨轉鬆，以轉動調整螺絲
⑩來調整。
⑷扣環供給端頭 出來時，使其先端比供給
底板②多 0.2mm。
【調整】轉鬆 來調整。
⑤
P19
②
①
①
⑩
⑨
3. Change and adjustment of buckle feeding
bed①
(1)Loosen screw②, and change the buckle
feeding bed①.
(2)When the buckle feeding bed① move to
the right most, align the center line④ of
the notch③and center line⑥ of 8-shaped
buckle holder.
【Adjustment】Loosen self-locking nut⑦
in order to turn the cylinder shaft for
adjustment.
(3)When the buckle feeding bed① move to
the right most, the gap between buckle
feeding bed① and 8-shaped buckle
holder⑤ are 0.5mm.
【Adjustment】Loosen screw⑨ in order
to turn the adjustable screw⑩ for
adjustment.
(4)While the buckle feeding front end
make it more 0.2mm than the feeding
bed②.
【Adjustment】Loosen
⑤
⑤
⑧ ⑦
①
out,
for adjustment.
① ④
③
⑥
①