Table of Contents
Advertisement
現象 Phenomenon
3. 製品的不良
(1) 肩帶縫製不良
(2) 肩帶完成時長度脫落
(3) 帶端不能縫入
3. Product defective
(1) Strap sewing defective
(2) Strap falls off
(3) Strap can not sew
properly
(4) 縫合部份錯開
a. 向上錯開
(4)Stitched part stagger
a.Stagger up
b. 向下錯開
b. Stagger down
原因 Reasons
•導帶滾輪的壓力力道過強
•導帶滾輪的壓力力道過弱
•肩帶反摺部份長度不足
•導帶板位置錯開
•Feeding strap roller force
of pressure too strong.
•Feeding strap roller force
of pressure too weak.
•Length of strap counter
folded part insufficient.
•Feeding strap plate
position different.
Introduction
對策 Strategies
•壓力力道轉弱 ( 將螺絲往左轉，箭頭 A
方向 )
•壓力力道轉強 ( 將螺絲往右轉，箭頭
B 方向 )
•Make the force weak. (Left turn the
screw, arrow A direction.)
•Make the force strong. (Right turn the
screw, arrow B direction.)
•將肩帶反摺長度放長。
【調整】
1. 轉鬆螺絲①，將刀具調整沿②向著
使氣缸③行程減短 (a 尺寸增長 ) 方
向移動
2. 轉鬆螺絲④，將極限開關安裝板⑤，
向←方向移動。
3. 轉鬆輸帶滾筒調整沿停止螺絲⑥，
將刀具到夾帶盒夾子⑦前端設定為
3 ～ 5mm
•Lengthen the strap folded part.
【Adjustment】
1.Loosen screw ① adjust knife
toward direction ② to make
cylinder ③ stroke shorter (size a
longer.)
2.Loosen screw ④ , to let limited
switch install plate ⑤ move toward
← direction.
3.Loosen feeding strap roller and
adjust stop screw ⑥ , to make the
distance between knife and front
end of strap-fixed device clamp ⑦
3-5mm.
④
⑤
②
A
B
⑥
3~5mm
⑦
① ③
P30
Advertisement
Table of Contents
