Change Of Circled-Buckle Feeding Upper End - Siruba ASP-BST100 Instruction Book And Parts List

6. 圓扣供給端頭 的交換
⑴ 轉鬆螺絲 ，交換圓扣供給端頭 。轉開
螺絲時，將螺絲 轉鬆把圓扣供給端頭
從上方撥開。組裝時將圓扣供給端頭 由
上方插入，並以螺絲 固定于其停止位
置。
7. 圓扣保持器①的交換
⑴ 將螺絲②轉開，交換圓扣盒①。
⑵ 圓扣保持器①與圓扣投放盤③的縫隙為圓
扣厚度的＋ 0.2mm。
【調整】以轉鬆螺絲④來調整。
P21
①
②
③
④
6. Change of circled-buckle feeding upper
end
(1)Loosen screw , change circled-buckle
feeding upper end . Loosen screw
, and push circled-buckle feeding upper
end aside. Assemble circled-buckle
feeding upper end
in the position by screw .
7.Change of circled-buckle feeding stand①
(1)Loosen screw② and change the circled-
buckle feeding stand①.
(2)The gap between circled-buckle feeding
stand① and circled-buckle putting plate
are the circled-buckle thickness＋0.2mm.
【Adjustment】Loosen screw④for
adjustment.
from up, and fixed it