Table of Contents
Advertisement
2. 調整式八字扣固定器③、④的調整
⑴ 將 2 顆螺絲①與 2 顆螺絲②轉鬆。
⑵ 將八字扣放入調整式八字扣固定器③、④
中，以 2 顆螺絲①與 2 顆螺絲②暫時固定。
⑶ 用手移動帶夾帶盒⑤，將其先端移至八字
扣中心附近。
⑷ 將 2 顆螺絲⑥轉鬆，並把氣缸⑦往箭頭⑧
的方向移動，當從箭頭 的方向推入八字
扣時，讓夾帶盒⑤的先端從八字扣的正中
央通過。
⑸ 將 2 顆螺絲①與 2 顆螺絲②轉鬆，軸⑨
的中心線與八字扣固定器③、④之間保留
0.2mm 左右的空隙。
⑤ ③ ②
⑤
②
④
①
相等
Equal
2.Adjustment of adjustable 8-shape feeding
holder ③,④
(1)Loosen two screws① and two screws②.
(2)Put 8-shaped buckles into adjustable
8-shaped buckle feeding stand③,④ and
use two screws① and two screws② to
fix it temporary.
(3)Move the strap-fixed device⑤with hands,
and moves its front end around the
8-shaped buckle center.
⑷Loosen two screws⑥, and move the
cylinder⑦ toward arrow⑧ direction. When
push the 8-shaped buckle to the direction
as arrow , let the front end of the strap-
fixed device⑤ make through the center of
8-shaped buckle.
⑸Loosen two screws① and two screws②,
align the the center line of shaft⑨ and
center line of 8-shaped buckle. Keep
around 0.2mm gap between 8-shaped
buckle holder③,④ .
⑥
⑦
相等
Equal
③
Introduction
⑧
⑩
④
⑨
P18
Advertisement
Table of Contents
