Installation - Siruba ASP-BST100 Instruction Book And Parts List

安裝
※ 注意：安裝作業需兩人以上執行。
1. 八字扣保持器①
⑴將座板②用螺絲③ (2 顆 ) 固定。
⑵安裝標準
八字扣保持器①與扣環供給底板④的縫隙
為 0.2mm。
扣環供給底板④倒退到最後時，讓八字扣
保持器①底部⑤的內側面和扣環供給下④
的槽一致。
②
③
④
2. 圓扣保持器⑦
⑴將圓扣保持器⑦用螺絲⑧ (2 顆 ) 固定。
⑵安裝標準
圓扣保持器⑦與圓扣供給底板⑨的縫隙為
圓扣厚度的 +0.2mm。

INSTALLATION

※Caution※ The installation work need two or
more people to proceed.
1.8-shaped buckle feeding stand ①
⑴Use two screws③ to fix plate② .
⑵Install standard
The gap of 8-shaped buckle feeding
stand ①and buckle feeding bed④ are
0.2mm.
As buckle feeding bed④ go backward
at the end, let the inner side of 8-shaped
buckle feeding stand①'s bottom⑤ and
the notch④under the buckle feeding
stand at the same position.
①
④
2.Circled-buckle feeding stand ⑦
⑴Use two screws⑧ to fix circled-buckle
⑵Install standard
⑦
⑧
⑨
Introduction
①
⑤
⑥
feeding stand ⑦.
The gap between circled-buckle feeding
stand⑦ and circled-buckle feeding
bed⑨ are the thickness of circled-
buckle +0.2mm.
P2