Table of Contents
Advertisement
4. 八字扣保持器①的交換
⑴將座板②與螺絲③轉開，交換八字扣保持
器①。
⑵八字扣保持器①與扣環供給底板④的縫隙
為 0.2mm。
【調整】以轉鬆螺絲③來調整。
⑶當扣環供給底板退後到最後側時，使八字
扣保持器①的底部⑤的內側面與扣環供給
底板④的溝⑥成一致。
【調整】以轉鬆螺絲③來調整。
②
③
④
5. 穿板⑦及導帶⑨的交換
⑴ 將 2 顆螺絲⑧轉開，交換穿板⑦。安裝時，
要使穿板⑦往箭頭 的方向均勻的進入八
字扣長孔 中。
⑵ 將 2 顆螺絲⑩轉開，交換導帶⑨。
⑦
4.Change of 8-shape buckle feeding stand①
(1)Loosen screw③ and bed② to change
8-shape buckle feeding stand①.
(2)The gap between 8-shape buckle feeding
stand① and buckle feeding bed④ are
0.2mm.
【Adjustment】Loosen screw③ for
adjustment.
(3)While buckle feeding bed back to the
most, make the bed inner side⑤ of the
8-shape buckle feeding stand① and the
notch⑥ of the buckle feeding bed④ at
the same position.
【Adjustment】Loosen screw③ for
adjustment.
①
5.Change of strap thread plate⑦ and strap
guide⑨
(1)Loosen two screws⑧, and change strap
thread plate⑦. While installing, make
sure to let strap thread plate⑦ through
the 8-shaped buckle hole
direction even.
(2)Loosen two screws⑩to change the strap
guide⑨.
Introduction
⑤
④
⑥
⑧
⑩
⑨
⑦
①
toward arrow
P20
Advertisement
Table of Contents
