Table of Contents
Advertisement
現象 Phenomenon
5. 按了啟動開關機械沒有開始
動作。( 停止燈燈亮 )
5. Machine without action after
turn ON. (Stop lamp lights
up.)
6. 八字扣被安裝至八字扣固定
器後機械沒有反應。( 燈滅 )
6. Machine didn't react after
install 8-shaped buckle at
8-shaped buckle holder.
(Lights off)
原因 Reasons
a. 八字扣、圓扣用完
b. 肩帶有接縫
c. 肩帶用完
d. 肩帶接縫開關在打開狀態
e. 肩帶確認燈燈亮 ( 當使用
薄肩帶的時侯 )
a. Run out of 8-shaped
buckle and circled-
buckle.
b. Strap has seam.
c. Run out of strap.
d. Strap seam sensor ON.
e. Strap checking lamp
lights up. (When use thin
strap.)
•八字扣穿棒沿調整不良
•The shaft which push
8-shaped buckle adjust
defective.
Introduction
對策 Strategies
a. 補充八字扣、圓扣。( 不要忘記墜子 )
b. 去掉接縫。
c. 安裝上新的肩帶。
d. 參照「（4）肩帶接縫檢測不良」的
解決方法。到燈滅為止感應器往→方
向移動。
【調整】
將螺絲①轉鬆進行
a. Supply 8-shaped buckle and
circled-buckle. (Don't forget
counterweight.)
b. Take off seam.
c. Install new strap.
d. Refer「（4）Strap seam detect
defective」solution until lamp lights
off, the sensor move toward →
direction.
【Adjustment】
Proceed after loosen screw ① .
①
電燈 Lamp
•從燈亮處到沿邊調整到 1mm
【調整】
將螺絲②轉鬆後進行
•Adjust from the light about1mm.
【Adjustment】
Proceed after loosen screw ② .
燈亮位置
燈亮位置
Position of lights
電燈
電燈
Lamp
②
P32
Advertisement
Table of Contents
