The Load Balance When Use A 1Φ / 220 V Motor Used On A 3 Φ / 220 V Power Source; How To Change Solenoid Supply Voltage (Dc 24 V Or 30 V) - Siruba C007K Manual

(4). The load balance when use a 1Φ / 220 V motor used on a 3 Φ / 220 V power
source.
See the following figure for the load balance.
R
S
T
(5). How to change solenoid supply voltage (DC: 24 V OR 30 V)
The JP1 is for
Caution:
Caution:
Turn off the power wait for 10 min. before open the
cover, then make the change.
Step 1
Step 2
P S A B C D
30 V and JP2 is for 24 V.
Before making the switch, check the machine head's Solenoid specification.
Remove 4 screws
of rear side
Remove 4 screws
of front side's right
24 V jumper setting
24V
JP 1
JP 2
24 V JP11
30 V
P S A B C D
Main board layout:
9
P S A B C D
：
High Voltage inside
30 V jumper setting
30V
JP 1
JP 2
JP11
24 V
30 V