Advertisement
送具調整
送具 (C) 升至上死點時，送具齒尖面與針板面
之距離為 1.0-1.2 mm( 圖 15)。
調整時：( 圖 16)
1. 放鬆送具 (C) 固定螺絲 (A)。
2. 上下移動送具 (C) 使符合上述條件時，再鎖
緊螺絲 (A)。
縫距之調整
首先確認馬達需關掉，然後壓下縫距調整按鈕
(A)，並轉動皮帶輪，會感覺卡一聲，即按鈕卡
住針距調整組，再轉動皮帶輪至所需之縫距，
欲調長縫距時，將皮帶輪往順時針方向旋轉，
反之則小，再放開此按鈕。( 圖 17)
P14
FEED DOG ADJUSTMENT
圖 15/Fig 15
When Feed Dogs (C) move to the upper dead
point, the distance from the tips of feed dogs to
the face of needle plate is 1.0-1.2 mm. (Fig. 15)
For adjustment：(Fig. 16)
1.Loosen Screw (A) on Feed Dog (C).
2.Move Feed Dog (C) up or down to meet
above requirement then tighten Screw (A).
STITCH LENGTH ADJUSTMENT
Be sure to turn off motor before adjust.
push stitch length Regulator Botton (A) and
turn pulley untill the botton lock in the stitch
regulator. Then, turn pulley again to reach
desired stitch length. Turn pulley clockwise
for longer stitch length, vice versa. Then,
release the botton. (Fig. 17)
圖 16/Fig 16
圖 17/Fig 17
Advertisement
