Installing The Internal Perc Riser - Dell DSS 2500 Owner's Manual

5 Follow the procedure listed in the After working inside your system section.
Related links
Safety instructions
Before working inside your system
Removing an expansion card from the internal PERC riser
Removing the cooling shroud

Installing the internal PERC riser

Installing the cooling shroud
Installing an expansion card into the internal PERC riser
After working inside your system
Installing the internal PERC riser
Prerequisites
1 Follow the safety guidelines listed in the Safety instructions section.
2 Follow the procedure listed in the Before working inside your system section.
3 If connected, disconnect the from expansion card(s).
4 If connected, remove the full length expansion card.
5 Remove the cooling shroud
6 If applicable, install the PERC card on the riser.
Steps
1 Align the guide slot on the internal PERC riser with the guide pin on the chassis.
2 Align the edge connector of the internal PERC riser with the PCIe connector on the system board.
3 Press down to lock the riser bracket to the chassis.
98 Installing and removing system components