Installing The Right Control Panel - Dell DSS 2500 Owner's Manual

Table of Contents

Advertisement

Installing the right control panel

Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1
Follow the safety guidelines listed in the Safety instructions section.
2
Follow the procedure listed in the Before working inside your system section.
3
Keep the T15 Torx screwdriver ready.
Steps
1
Fold the PPID label around the cable.
2
Push the cable until the cable passes completely through the channel.
CAUTION:
To prevent damage to the right control panel cable, you must release the locking tab before removing or installing
the right control panel cable from the connector on the hard drive backplane.
3
If locked, rotate the locking tab on the right control panel cable connector clockwise 90 degrees to release the lock.
4
Connect the right control panel cable to the connector on the hard-drive backplane.
5
Rotate the locking tab on the right control panel cable connector counter clockwise 90 degrees to secure the lock.
6
Tighten the screws to secure the right control panel to the chassis.
NOTE:
You must route the cable properly to prevent it from being pinched or crimped.
140
Installing and removing system components

Advertisement

Table of Contents
loading

Table of Contents