Installing The (Optional) 2.5 Inch Internal Hard Drive Cage - Dell DSS 2500 Owner's Manual

Related links
Before working inside your system
Removing the dual riser module (optional)
Removing the internal PERC riser
Removing the cooling shroud
Removing the (optional) 2.5 inch internal hard drive carrier

Installing the (optional) 2.5 inch internal hard drive cage

Installing the (optional) 2.5 inch internal hard drive carrier
Installing the cooling shroud
Installing the internal PERC riser
Installing the dual riser module (optional)
After working inside your system
Safety instructions
Installing the (optional) 2.5 inch internal hard drive cage
Prerequisites
1 Follow the safety guidelines listed in the Safety instructions section.
2 Follow the procedure listed in the Before working inside your system.
3 Keep the Phillips #2 screwdriver ready.
4 If connected, disconnect the cables from expansion card(s).
5 If required, remove the PCIe expansion card riser.
NOTE: If applicable, close the expansion card latch on the cooling shroud to release the full length card.
6 Remove the cooling shroud.
7 Disconnect the power and data cables from the hard drive.
8 Disconnect the FAN1 cable from the power interposer board.
NOTE: The FAN1 cable is routed behind the internal hard drive cage.
Steps
1 Align the internal hard drive cage guide with the guide slots on the chassis.
2 Insert the internal hard drive cage into the chassis.
3 Install the screw to secure the internal hard drive cage to the chassis.
Installing and removing system components 85