Removing The (Optional) 2.5 Inch Internal Hard Drive From The Internal Hard Drive Carrier - Dell DSS 2500 Owner's Manual

Related links
Safety instructions
Before working inside your system
Removing the cooling shroud
Removing the (optional) 2.5 inch internal hard drive carrier
Removing the internal PERC riser
Installing the internal PERC riser
Installing the cooling shroud
After working inside your system
Removing the (optional) 2.5 inch internal hard drive from the
internal hard drive carrier
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1 Follow the safety guidelines listed in the Safety instructions section.
2 Follow the procedure listed in the Before working inside your system section.
3 Keep the Phillips #2 screwdriver ready.
4 Disconnect the power and data cables from the hard drive.
5 Remove the internal hard drive carrier.
Steps
1 Remove the screws that secure the hard drive to the internal hard drive carrier.
2 Slide the hard drive out of the internal hard drive carrier.
Figure 31. Removing the (optional) 2.5 inch internal hard drive from the internal hard drive carrier
1 screw (8)
3 hard drive
Next step
Follow the procedure listed in the After working inside your system section.
2 internal hard drive carrier
Installing and removing system components 81