Installing The Internal Perc Riser - Dell PER4402A Installation And Service Manual

Figure 48. Removing internal PERC riser
5. Turn the internal riser so that the PERC card is facing up.
6. Press the cable connector and disconnect the cable that is connected to the internal PERC card.
Figure 49. Disconnecting the cable from internal PERC card
Next steps
1. Install the air shroud.
2. Follow the procedure listed in
3. Install the internal PERC card.

Installing the internal PERC riser

NOTE: The new generation PERC 11 H750, H350, and HBA350i adapters cannot be mixed with the PERC H740P, H730P,
H330, HBA330 adapters of the previous generations in one system. For more information, see
Prerequisites
Follow the safety guidelines listed in
58 Installing and removing system components
After working inside your
Safety instructions.
system.
Cable routing.