Removing The Internal Perc Riser - Dell DSS 2500 Owner's Manual

Removing the internal PERC riser

Prerequisites
1 Follow the safety guidelines listed in the Safety instructions section.
2 Follow the procedure listed in the Before working inside your system section.
3 If connected, disconnect the cables from the expansion card(s).
4 If required, remove the dual riser module.
5 Remove the cooling shroud.
Step
Hold the internal PERC riser module by the edges and lift it out of the system.
Figure 41. Removing the internal PERC riser
1 internal PERC riser module
3 internal PERC riser
5 PCIe connector on system board
Next steps
1 Install the cooling shroud.
2 If removed, reinstall the dual riser module.
3 Reconnect all disconnected cables.
4 If required, open the expansion card latch on the cooling shroud to support the full length expansion card.
2 guide slot on the internal PERC riser (2)
4 guide pin on the chassis (2)
Installing and removing system components 97