Removing The Dual Riser Module (Optional) - Dell DSS 2500 Owner's Manual

Removing the dual riser module (optional)

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1 Follow the safety guidelines listed in the Safety instructions section.
2 Follow the procedure listed in the Before working inside your system.
3 If connected, disconnect the cables from expansion card(s).
Step
Holding the dual riser module by the finger holds, lift the dual riser module from the riser connector on the system board.
Figure 39. Removing the dual riser module
1 full height expansion card latch
3 expansion card riser (2)
Next steps
1 If removed, reinstall the expansion card(s) onto the dual riser module.
2 If disconnected, connect the power or data cables to the expansion card(s).
3 Install the dual riser module.
4 Follow the procedure listed in the After working inside your system section.
Related links
Safety instructions
Before working inside your system
Installing an expansion card into the dual riser module
Installing the dual riser module (optional)
After working inside your system
2 dual riser module
4 PCIe connector on the system board (2)
Installing and removing system components 95