Dell DSS 2500 Owner's Manual page 102

Figure 44. Installing an expansion card into the internal PERC riser
1 expansion card guide slot on internal PERC riser
3 internal PERC riser
5 release tab
Next steps
1 Follow the procedure listed in the After working inside your system section.
2 Install the internal PERC riser on the system board.
3 Install the cooling shroud.
4 Reconnect the disconnected cables to the expansion card(s).
5 If removed, reinstall the dual riser module.
NOTE: If closed, open the expansion card latch on the cooling shroud to support the full length card.
Related links
Safety instructions
Before working inside your system
Removing the dual riser module (optional)
Removing the cooling shroud
Removing the internal PERC riser
Removing an expansion card from the internal PERC riser
Installing the internal PERC riser
Installing the cooling shroud
Installing the dual riser module (optional)
After working inside your system
102 Installing and removing system components
2 expansion card
4 PCIe connector on internal PERC riser card
6 locking notch on the expansion card