Removing The (Optional) 2.5 Inch Internal Hard Drive Cage - Dell DSS 2500 Owner's Manual

Related links
Safety instructions
Before working inside your system
Removing the (optional) 2.5 inch internal hard drive from the internal hard drive carrier
After working inside your system

Removing the (optional) 2.5 inch internal hard drive cage

Prerequisites
1 Follow the safety guidelines listed in the Safety instructions section.
2 Follow the procedure listed in the Before working inside your system section.
3 Keep the Phillips #2 screwdriver ready.
4 If connected, disconnect the cables from expansion card(s).
5 If required, remove the PCIe expansion card riser.
NOTE: If applicable, close the expansion card latch on the cooling shroud to release the full length card.
6 Remove the cooling shroud.
7 Disconnect the power and data cables from the hard drive.
8 Remove the internal hard drive carrier.
9 Disconnect the FAN1 cable from the power interposer board.
NOTE: The FAN1 cable is routed behind the internal hard drive cage.
Steps
1 Remove the screw that secures the internal hard drive cage to the chassis.
2 Lift the internal hard drive cage out of the chassis.
Installing and removing system components 83