Dell DSS 2500 Owner's Manual page 127

Figure 64. Installing the power interposer board
1 FAN1 power connector
3 hook (4)
5 power interposer board
Next steps
1 If applicable, install the PCIe expansion card riser.
2 If applicable, connect the required power or data cables to the expansion card(s).
3 Install the internal hard drive cage.
4 Install the internal hard drive carrier.
5 Reinstall the cooling shroud.
6 If applicable, open the expansion card latch on the cooling shroud to secure the full length expansion card.
7 Follow the procedure listed in the After working inside your system section.
Related links
Safety instructions
Before working inside your system
Removing the cooling shroud
Removing the (optional) 2.5 inch internal hard drive carrier
Removing the (optional) 2.5 inch internal hard drive cage
Removing the power interposer board
Removing the dual riser module (optional)
Removing the internal PERC riser
Installing the internal PERC riser
Installing the dual riser module (optional)
Installing the (optional) 2.5 inch internal hard drive cage
Installing the (optional) 2.5 inch internal hard drive carrier
Installing the cooling shroud
After working inside your system
2 release latch
4 locking slot (4)
Installing and removing system components 127