Download  Print this page

Initial System Setup And Configuration; Setting Up Your System; Options To Set Up Bmc Ip Address; Log In To Bmc - Dell DSS 2500 Owner's Manual

Hide thumbs

Advertisement

Setting up your system

Complete the following steps to set up your system:
1
Unpack the system.
2
Install the system into the rack. For more information about installing the system into the rack, see your system Rack Installation
Placemat at Dell.com/dssmanuals.
3
Connect the peripherals to the system.
4
Connect the system to its electrical outlet.
5
Turn the system on by pressing the power button.
6
Turn on the attached peripherals.

Options to set up BMC IP address

You must configure the initial network settings based on your network infrastructure to enable the communication to and from BMC. You
can set up the IP address by using one of the following interfaces:
Interfaces
Document/Section
iDRAC Settings
See Dell Integrated Dell Remote Access Controller User's Guide at Dell.com/idracmanuals
utility
Dell Deployment
See Dell Deployment Toolkit User's Guide at Dell.com/openmanagemanuals
Toolkit
Remote Access
See RACADM Command Line Interface Reference Guide and Integrated Dell Remote Access Controller User's
Controller Admin
Guide at Dell.com/idracmanuals
(RACADM)
Remote Services
See Dell Integrated Dell Remote Access Controller User's Guide at Dell.com/idracmanuals
that include Web
Services
Management (WS-
Man)
You must use the default BMC IP address 192.168.0.120 to configure the initial network settings, including setting up DHCP or a static IP for
BMC.
NOTE:
To access BMC, ensure that you install the remote management port card or connect the network cable to the Ethernet
connector 1 on the system board.
NOTE:
Ensure that you change the default user name and password after setting up the BMC IP address.

Log in to BMC

You can log in to BMC as:
26

Initial system setup and configuration

Initial system setup and configuration
4

Advertisement

   Related Manuals for Dell DSS 2500

Comments to this Manuals

Symbols: 0
Latest comments: