Dell DSS 2500 Owner's Manual page 137

3 Keep the T15 Torx screwdriver ready.
Steps
1 Fold the PPID label around the cable.
2 Fold the pull tab close to the connector and guide the connector and pull tab into the channel.
3 Push the cable until the cable passes completely through the channel.
4 Tighten the screws to secure the left control panel to the chassis.
NOTE: You must route the cable properly to prevent it from being pinched or crimped.
5 Connect the cable connector to the hard drive backplane by pushing on the center of the connector.
Figure 73. Installing the left control panel
1 screw (3)
3 hard drive backplane
5 left control panel connector on hard drive backplane
Next step
Follow the procedure listed in the After working inside your system section.
Related links
Safety instructions
Before working inside your system
Removing the left control panel
After working inside your system
2 left control panel
4 left control panel connector
6 plastic pull tab
Installing and removing system components 137