Installing The Internal Perc Card - Dell PowerEdge R330 Owner's Manual

Figure 61. Removing the internal PERC card
1. screw (2)
3. PERC card
5. PERC card LED cable
7. LED cable connector on the system board
Next steps
1. Install the internal PERC card.
2. Install the expansion card riser.
3. Follow the procedure listed in the After working inside your system section.
Related links
Removing the expansion card riser
Installing the expansion card riser

Installing the internal PERC card

Installing the internal PERC card
Prerequisites
1. Follow the safety guidelines listed in Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Remove the expansion card riser.
4. Keep the Phillips #2 screwdriver ready.
Steps
1. Connect the PERC LED cable to the LED cable connector on the PERC card.
2. Insert the PERC card in the PERC card slot.
3. Press and slide the tab on the PERC card lock to disengage it from the slot on the chassis.
4. Turn the internal PERC card lock to engage it with the PERC card.
5. Install the first screw to secure the PERC card lock to the PERC card.
6. Install the second screw to secure the PERC card to the chassis.
NOTE: Use the two screws supplied with the system to secure the PERC card to the PERC card lock and the
chassis
7. Connect the PERC LED cable to the LED cable connector on the system board.
2. PERC card lock
4. LED cable connector on the PERC card
6. PERC card connector
99