Figure 108. Removing the Internal mini PERC card
Next steps
1.
Replace the internal mini PERC
Installing the Internal mini PERC card
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air
shroud.
4. If applicable,
remove the rear drive
5. If applicable,
remove the expansion card
6.
Remove the PERC card air
Steps
1. Align and insert the internal mini PERC card at an angle into the PERC card slot.
2. Tighten the screws to secure the internal mini PERC card to the system.
3. Connect the SAS cable to the backplane.
102
Installing and removing system components
card.
Safety instructions
Before working inside your system
cage.
riser.
shroud.
on page 26.
on page 27.