Removing A 1.8-Inch Hard Drive From A Hard Drive Carrier; Installing A 1.8-Inch Hard Drive Into A Hard Drive Carrier - Dell PowerEdge R630 Owner's Manual

Figure 37. Installing a hot swappable hard drive into a hot swappable hard drive carrier
1. screw (4)
2. hard drive
3. hard drive carrier

Removing a 1.8-inch hard drive from a hard drive carrier

1. Follow the safety guidelines listed in the Safety instructions section.
2. Remove the hard drive carrier from the system.
1. Turn the hard drive carrier.
2. Pull the rails of the hard drive carrier and lift the hard drive out of the hard drive carrier.
Figure 38. Removing a 1.8-inch hard drive into a hard drive carrier
a. hard drive carrier
b. hard drive
Related references
Safety instructions

Installing a 1.8-inch hard drive into a hard drive carrier

CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
Insert the hard drive into the hard drive carrier with the connector end of the hard drive toward the back.
When aligned correctly, the back of the hard drive is flush with the back of the hard drive carrier.
Installing and removing system components 89