Table of Contents
Advertisement
Operating instructions
4.2.2 Machines with manual hood lift
•
•
4.2.3 Machines with an automatic hood lift (option)
•
•
•
4.2.4 Changing the water
The drain lever (10) can be turned to three different positions.
Left: The machine's tanks are closed.
Right: WD-PRM6/7 tank open to drain and the dishwasher's tank closed.
Middle position (downwards): Both the machine's tanks are now open to the
drain.
The water in the machine does not normally need changing but this can be done.
If you nevertheless want to change the water in WD-PRM6/7, this is what you
should do:
•
•
•
•
•
Push in the basket and close the hood. The pre-rinse will start automatical-
ly.
The pre-rinse will have finished after a set amount of time (the time may be
adjusted by authorised personnel). Open the hood and push the basket
into the dishwasher for washing and final rinsing.
Push in the basket and close the hood by pressing the button (9). The pre-
rinse will start.
If the machine is fitted with autostart (1), the hood is closed automatically
when a basket is loaded. The pre-rinse will start. (option)
The pre-rinse will have finished after a set amount of time and the hood will
open automatically (the time may be adjusted by authorised personnel).
Push the basket into the dishwasher for washing and final rinsing.
PRM
PRM
Turn the drain lever (10) to the right as far as it will go.
The water is now emptied out from WD-PRM6/7.
Take out the strainers (2) and clean these, refit them.
Turn back the drain lever (10) as far to the left as it will go.
WD-PRM is now refilled automatically with water via the connected dish-
washer.
WD-PRM6 & WD-PRM7
PRM
25
Rev. 5.0 (201902)
400046.31
Advertisement
Table of Contents
