Adjusting The Height - Canon DADF-N1 Service Manual

host machine.
2. Inch-Configuration Adjustment
1) Start service mode.
Starting Service Mode
Press the User Mode key, press the 2 and 8
keys at the same time, and press the User
Mode key once again.
2) Touch the following notations in
sequence to bring up the Adjustment
screen:
1 FEEDER
2 FUNCTION
3 TRY-LTR (to highlight)
3) Adjust the tray side guide to the LTR/
11x17 index.
4) Press [OK] to register the LTR width.
5) Press [TRY-LTRR] to highlight
6) Adjust the tray side guide to the STMT/
LTRR/LGL index.
7) Touch [OK] to register the LTRR width.
8) Press the Reset key twice to end service
mode.
9) Hold down the control panel power
switch of the host machine for 3 sec or
more.
10) Go through the shutdown sequence
indicated on the screen so that the main
power switch will be ready to be turned
OFF.
11) Turn OFF the main power switch of the
host machine.
12) Turn ON the main power switch of the
host machine.
4.3.1.3 Adjusting
Height
1. Making Pre-Checks
Check to see that that the original butting
segment on the pickup side is in full
contact with the copyboard glass at both
front and rear when the DADF is closed.
F-4-19
MEMO
Place a sheet of paper between the ADF
reading glass and the original butting
segment on the pickup side. It is desirable
if drawing the paper in the direction of the
arrow gives you a touch of resistance.
Chapter 4
the
0006-2349
4-15