Detaching The Timing Belt And The Pulley - Canon DADF-N1 Service Manual

Chapter 3
F-3-129
3) Remove the 2 screws [4] and the stepped
screw [5]; then, detach the feed motor
[6] together with the adjusting plate [7].
[5]
[4]
F-3-130
3.4.6.8
Detaching the
Timing Belt and the
Pulley
1) Disconnect the 2 connectors [1], and
remove the screw [2] and grounding
fixing screw [3]; then, slide the harness
guide slightly to the left, and lift it.
3-36
[3]
[7] [4]
0007-5779
[3]
F-3-131
2) Remove the 4 screws [4] and the other
screw [5]; then, detach the left hinge
unit.
[6]
[5]
F-3-132
3) Remove the screw [6], and detach the
original placement sensor [7] together
with the bracket; then, disconnect the
connector [8].
[1]
[4]
[2]