Table of Contents
Advertisement
[1]
2. Adjust the position of the front cover by using 4 screws on it so that gap
A between the front cover [1] and the front cover top [2] is 3 -/+1 mm.
3. If you moved the paper level indicator belt or the deck lifter, you must ad-
just the paper level indicator.
[1]
Adjusting the Paper Level Indicator
1) Move the drive belt [2] of the paper level indicator found in the front cover
[1] in the direction of the arrow [4] lightly by hand (i.e., so that the area
of white increases).
[1]
[4]
Keep in mind that you can damage the drive mechanism of the paper level
indicator if you operate the deck without correcting the spatial relationship
between the paper level indicator and the deck lifter.
2) With the compartment set in the deck, turn the 4 mounting screws [4] of
the spacer support plate [3] so that the distance A between the spacer [1]
and the floor [2] is about 5 mm.
F-4-7
[2]
F-4-8
[3]
[2]
F-4-9
[4]
[3]
[1]
At this time, use the index [5] on the front side plate as a reference.
4.2.1.5 Adjusting the Height of the Side Spacer
a. Before Starting the Work
1) Slide the machine out of its host machine, and then slide it back in. Check
to see if the impact of the movement has displaced the host machine or if
the machine has wobbled. If so, adjust the height of the side spacer; oth-
erwise, this adjustment may be skipped.
b. Making Adjustments
1) Connect the machine to its host machine.
2) Remove all paper from the deck.
3) Remove the machine's right cover.
4) Loosen the 2 fixing screws [2] of the side spacer [1].
5) Bring the side spacer in contact with the floor, and tighten the fixing
screw.
At this time, refer to the indexes so that the left and right screws are at the
index.
6) Disconnect and then connect the machine from and to its host machine. If
the movement is not heavy, attach the machine's right cover, put paper
back in, and then end the work. If the movement is heavy, go to the next
step.
7) Check the index of the side spacer.
8) Loosen the side spacer fixing screw.
9) By referring to the index, move the side spacer up by 1 mm; then, tighten
the fixing screw.
10) Attach the right, and put paper in the deck.
4.2.1.6 Swithcing the Paper Size of the Deck
As needed to suit the user's needs, go through the following to change the
deck paper size:
1) Push the deck releasing grip [1] to detach the deck from the host machine;
then, push down the latch plate [2] found at the left rear with a finger to
open the compartment.
Chapter 4
[5]
[4]
A
[2]
F-4-10
[2]
[1]
F-4-11
0023-7357
0023-7358
4-3
Advertisement
Table of Contents
