CHAPTER 2 STANDARDS AND ADJUSTMENTS
A. Image Adjustment
1. Adjusting the Image Leading Edge Margin ([3], No. 305; registration ON timing)
Activate [3] in service mode, and select 'No. 305' (leading edge margin adjustment),
and make adjustments so that the image position is as indicated in Figure 2-1 when the
Test Sheet is copied in Direct.
Making Adjustments
1) Activate [3] in service mode, and select 'No. 305' using the keypad.
•
The copy count indicator flashes 'No. 305'.
2) Press the Start key.
3) Change the value using the keypad.
•
The value flashes.
•
If the value is negative, '%' turns on. To enter a negative value, press the % key,
then enter the value using the keypad.
4) Press the AE key.
•
The value flashes as soon as it is entered.
•
Press the Start key to start copying operation.
5) To change a value continuously, repeat steps 1) through 4).
6) Press the Clear key to return to selecting items.
The relationship between the setting and the image position is as follows:
•
For each '1' in the setting, the position shifts about 0.27 mm.
•
'+' shifts the image forward.
CHAPTER 2 STANDARDS AND ADJUSTMENTS
2.5±1.5mm
Figure 2-1
2
2-1