Switch Setting - Mitsubishi Electric MELSEC QS SERIES User Manual

6
PROCEDURES AND SETTINGS BEFORE SYSTEM
OPERATION

6.6 Switch Setting

This section describes the procedure before starting the data link with the settings of the
link ID setting switch, station number setting switch and transmission speed setting switch
of the safety remote I/O module.
(1) Switch setting procedure
Setting start
Turn OFF the power supply
of the safety remote I/O
module.
Change the link ID setting
switch, station No. setting
switch and transmission speed
setting switch.
Turn ON the power supply
of the safety remote I/O
module.
Can "L ERR."
LED turn on?
NO
Press the setting saving switch
once.
1
6
- 27 6.6 Switch Setting
Switch setting must be made in the power-OFF status of the safety remote I/O
module.
If the switch setting is made with the module power ON, it may result in incorrect
output or malfunction.
Fully confirm the safety of the module when setting the switches with the module
power ON.
To return to the CC-Link Safety system with the changed switch setting, the reset
operation or power OFF
After making or canceling the switch setting, be sure to perform the reset operation or
turn the power OFF
YES
Perform a troubleshooting
referring to Item 1 of (2) in
(2) in this section.
this section
ON of the safety remote I/O module is required.
ON of the safety remote I/O module.
RESET
LINK ID STATION NO. B RATE
LBT
0 1
EL
2
7 3
6 4
5
Link ID setting switch
RESET
LINK ID STATION NO. B RATE
LBT
0 1
EL
2
7 3
6 4
5
SET
0 1 0 1 0 1
9
2 8 2 2
3 7 3 3
6 4 6 4 4
5 5
X10 X1
Transmission speed setting switch
Station No. setting switch
Setting saving switch
SET
0 1 0 1 0 1
9
2 8 2 2
3 7 3 3
6 4 6 4 4
5 5
X10 X1