Mitsubishi Electric MELSEC QS SERIES User Manual page 74

Programmable controller cc-link safety system remote i/o module
Hide thumbs Also See for MELSEC QS SERIES:
Table of Contents

Advertisement

6
PROCEDURES AND SETTINGS BEFORE SYSTEM
OPERATION
No.
Name
"SD"
Indicator
1)
"RD"
LEDs
"X0" to "XF"
"Y0" to "Y3"
2)
Link ID setting switch
3)
Station No. setting switch
Transmission speed setting
4)
switch
5)
Setting saving switch
6)
Reset switch
7)
I/O terminal block
8)
Power supply, transmission
9)
terminal block
10)
Hook for DIN rail
11)
Holding fixtures for screw
12)
installation (Accessories)
Fixing hole for screw
13)
installation
6
- 11
6.3 Part Names and Settings
Indicates the sending status of the safety remote I/O module in the CC-Link Safety
System.
On (green)
: Data being sent
Indicates the receiving status of the safety remote I/O module in the CC-Link Safety
System.
On (green)
: Data being received
Indicates the I/O status of the safety remote I/O module.
On (red)
: I/O ON
Off
: I/O OFF
Setting
0 to 7
Link ID setting
Setting for reading error logs
EL
(For error logs, refer to Section 4.5.)
Setting for self-loopback test
LBT
(For Setting for self-loopback test, refer to Section
6.4.)
To refresh the switch setting, perform the reset operation or turn the power OFF
of the safety remote I/O module.
Set station No. of the safety remote I/O module within a range from 0 to 64. *3
• Tens place of station No. is set by
• Units place of station No. is set by
Setting
0
1
2
3
4
Always set this switch within a range of 0 to 4.
Saves the values set by switches 2) to 4) into the nonvolatile memory inside the safety
remote I/O module.
Resets the hardware of the safety remote I/O module.
Two-piece terminal block for connection of external power supply and I/O signals.
Two-piece spring clamp terminal block for connection of external power supply and I/O
signals.
Two-piece terminal block for connection of module power supply and transmission
signal.
Hook used for installing the module to a DIN rail.
Press the center part of the hook until a click is heard.
Attached to a module when installing it directly to a panel.
(Available in two ways, 11) and 12).)
A hole used when installing a module directly to a panel.
Description
Description
X10.
X1.
Transmission speed
156kbps
625kbps
2.5Mbps
5Mbps
10Mbps
ON

Advertisement

Table of Contents
loading

Table of Contents