Mitsubishi Electric MELSEC QS SERIES User Manual page 62

5
PARAMETER SETTING
(1) Method of wiring of output
26. Method of wiring of output Y0
27. Method of wiring of output Y1
28. Method of wiring of output Y2
29. Method of wiring of output Y3
(2) Output dark test selection
30. Output dark test selection Y0
31. Output dark test selection Y1
32. Output dark test selection Y2
33. Output dark test selection Y3
5
- 19 5.2 Parameter Details
5.2.2 Output parameter
This parameter is used to set a wiring method for each output point.
The settings are shown in Table5.11.
Table5.11 Settings
Parameter item
When a value out of the setting range is set, the following errors occur.
• Out of the setting range of "Method of wiring of output"
• Output wiring method combination error
For details of the errors, refer to Section 9.5.
This parameter is used to set in the output point unit whether the "Output dark test
function" of the safety remote I/O module diagnostic function is executed or not.
The settings are shown in Table5.12.
Table5.12 Settings
Parameter item
When a value out of the setting range is set, the following errors occur.
• Out of the setting range of "Output dark test selection"
• Output dark test selection combination error
For details of the errors, refer to Section 9.5.
Setting range
"No Use",
"Double wiring (Source+Sink)",
"Double wiring (Source+Source)"
Setting range
"Execute",
"Not execute"
Default
"No Use"
Default
"Execute"