Table of Contents
Advertisement
PAN301x Bluetooth Module
4.5 Configuration Settings
Operation over X1 (Micro-USB)
Operation over P7 → Set jumper at P10
due to UART control (USB or P9)
Use connector P9 only with the FTDI USB to UART cable "TTL-232R-3V3".
Jumper
Description
P1
Supply voltage for the level shifter at P9. Set this jumper if using serial communication over
P9 (FTDI cable "TTL-232R-3V3").
P2
Connects the RGB LED to DIO0, DIO3, and DIO14 of the sensor module.
P4
Supply voltage of the sensor module over µUSB/P9 or over P7
P5
Supply voltage of the sensor module over µUSB/P9/P7 or over CR2032 coin cell
Module Integration Guide Rev. 1.0
Operation over P9 (TTL-232R-3V3 cable)
Operation over CR2032 battery (without
UART control)
4 Reference Design
Page 17 of 30
Advertisement
Table of Contents
