Accessing Domestic Hot Water Production Mode; Start-Up - DeDietrich GSHP 5 MR-E User Manual

5 Operation
Fig.20 Accessing heating mode
# F

% $
AUTO
J I
STD
Fig.21 Accessing the User level
# F 
% $
AUTO
J
I
STD
Fig.22 Accessing the domestic hot water
production mode
F
# 
% $
AUTO
J I
STD
5.2

Start-up

Fig.23 Powering up
Fig.24 Language Selection
0 2 4 6 8 10 12 14
LANGUE
Français - Deutsch - English -
E 1
Italiano - Espanol - Nederlands
- Pycck - Polski - Türk -
2
1
D
2
bar
# F !

% $
J I
STD
26 GSHP
!
:
<
!
:
<
! :
<
3
MW-6000059-2
16 18 20 22 24
FRANCAIS
MW-C002286-C
2. Go to the heating configuration mode by pressing the
3. Select the desired menu by turning the settings button.
4. Confirm the selection by pressing the settings button.
5. Go back to the main display by pressing the
5.1.4

Accessing domestic hot water production mode

1. Go to the User level by pressing the
2. Go to the domestic hot water production configuration mode by
pressing the key.
3. Select the desired menu by turning the settings button.
4. Confirm the selection by pressing the settings button.
5. Go back to the main display by pressing the
1. Open the control panel flap.
2. Start up the heat pump by pressing the ON/OFF switch.
3. The first time the boiler is powered up, the LANGUAGE parameter is
displayed. Select the desired language by turning the settings but­
ton.
4. Confirm the selection by pressing the settings button. The heat
pump begins an automatic venting cycle that lasts around 3 minutes
and is repeated each time the power is cut. If there is a problem, the
error is displayed on the screen.
5. Check the hydraulic pressure in the installation shown on the control
panel display.
Note
Recommended hydraulic pressure between 0.15 and 0.2
MPa (1.5 and 2.0 bar).
6. Close the control panel flap.
key.
key once.
key.
key.
7636860 - v04 - 18012017