Table of Contents
Advertisement
5 Operation
Fig.27
MW-5000135-3
Fig.28
Fig.29
5.4
Frost Protection
30
5.3.2
1. Go to stop mode by pressing the
2. Select domestic hot water production mode pressing the
3. Confirm by pressing the
MW-5000136-3
4. Select domestic hot water production shut-down by pressing the
MW-5000028-4
5. Confirm by pressing the
6. Go back to the main display by pressing the
5.3.3
1. Access the
2. Confirm access by pressing the
3. Select CIRCA or CIRCB by pressing the
4. Confirm the selection by pressing the
5. Select TP.C by pressing the
6. Confirm the selection by pressing the
7. Modify the timer program to stop cooling.
If the temperature of the heating water in the heat pump falls too much,
the integrated protection device switches itself on. This device functions as
follows:
Stopping domestic hot water production
Important
Domestic hot water production can be managed via the TIME
PROG sub-menu dedicated to timer programming.
key.
The screen displays:
The frost protection function continues to run.
Production of domestic hot water has been shut down.
Important
Press the
key to restart the appliance: the screen will
display
.
Important
The display disappears after a few seconds of inactivity.
Shutting down the cooling function
Important
If the heating function is shut off, then the cooling will also be shut
off.
menu.
key.
key.
.
key.
key.
key.
or
key.
key.
or
keys.
key.
7611444 - v06 - 04032019
key.
Advertisement
Table of Contents
Troubleshooting
