Recommendations - DeDietrich GSHP 5 MR-E User Manual

1.2

Recommendations

7636860 - v04 - 18012017
Caution
If the heat pump is not wired in the factory, carry
out the wiring according to the wiring schematics:
refer to the chapter Electrical Connections in the
Installation and Service Manual.
Caution
In order to prevent any danger owing to the unex­
pected reset of the thermal circuit breaker, this
appliance must not be powered through an exter­
nal switch, such as a timer, or be connected to a
circuit which is regularly switched on and off by
the electricity provider.
Caution
Separate the very low voltage cables from the
230/400 V circuit cables.
Danger of electric shock
Before any work, switch off the mains supply to
the heat pump.
Important
This manual can also be found on our internet
site.
For more information, see
Technical specifications, page 14
Important
Keep this document close to the place where the
appliance is installed.
Important
Allow the space required to correctly install the
heat pump. Refer to the Overall space needed for
the heat pump section in the installation and serv­
ice manual.
Note
Only qualified professionals are authorised to as­
semble, connect, commission and service the in­
stallation.
Caution
Remove the heat pump casing only to perform
maintenance and repair work. Always put the
casing back in place after such work.
1 Safety
GSHP 7