Stopping Domestic Hot Water Production; Shutting Down The Cooling Function; Frost Protection - DeDietrich ALEZIO O HYBRID User Manual

Fig.33
MW-5000135-3
Fig.34
Fig.35
5.5

Frost Protection

7613346 - v05 - 13112018
5.4.2
1. Go to stop mode by pressing the
2. Select domestic hot water production mode pressing the
3. Confirm by pressing the
MW-5000136-3
4. Select domestic hot water production shut-down by pressing the
MW-5000028-4
5. Confirm by pressing the
6. Go back to the main display by pressing the
5.4.3
If the temperature of the heating water in the heat pump falls too much,
the integrated protection device switches itself on. This device functions as
follows:
If the water temperature is lower than 5°C, the circulating pump starts
up.
If the water temperature is lower than 3°C, the back-up starts up.

Stopping domestic hot water production

Important
Domestic hot water production can be managed via the TIME
PROG sub-menu dedicated to timer programming.
key.
The screen displays:
The frost protection function continues to run.
Production of domestic hot water has been shut down.
Important
Press the key to restart the appliance: the screen will
display .
Important
The display disappears after a few seconds of inactivity.

Shutting down the cooling function

Important
The cooling function can be managed using the
in the timer programming sub-menu
Important
If the heating function is shut off, then the cooling will also be shut
off.
key.
key.
.
key.

key.
.
200 ESL HYBRID
5 Operation
key.
parameter
31