Table of Contents
Advertisement
6-4
LCD Error
Message
Track Encoding
Error N
Transport Jam
Error Messages
Problem:
Error detected while verifying magnetically encoded card
on track n, where n is the number of the encoding track
reporting error.
Cause:
Bad card, Magnetic Encoder Head possibly out of
alignment, start sentinel has wrong setting (check
"Encode Start", "Encode W/R Delay", "Wheel Count to
Edge", and "Start Check Tolerance" parameters).
Operator
Remove card and try again, check settings
Action:
For mechanical problems contact NBS Service Rep.
Problem:
Transport servo reports a jammed condition.
Cause:
Jammed card sometimes occurs when there is
resistance to running the transport, also can occur if
"Max Speed" set too high (typically above 65), or a
jammed drive belt.
Operator
Remove jammed card, check and correct settings.
Action:
For mechanical problems contact NBS Service Rep.
NBS Technologies Inc.
Description
Chapter 6 Page 4
Hide quick links:
Advertisement
Table of Contents
