NBS Technologies ImageMaster D-40 Operation Manual page 53

5-6
5. After fixing the tape in place, remount the retainer and tighten to prevent the core from
sliding.* Also, ensure that the screw is inserted into a notch on the cardboard core.
The take-up spool has a roll pin that must be inserted in the retainer plate when
NOTE:
mounting. This is added insurance that the core will not slide on the spool.
6. Press the [CTRL]+[K] keys to initiate the cleaning tape. It will continue to run until the
[CTRL]+[K] keys are pressed again. Ensure that there is no slippage and that the tape
moves freely and evenly. However, movement of the tape will be "strained" due to the
adhesive.
Front View
Retainer Knob
Retainer Plate
Retainer
Knob
Retainer
Plate
Supply
Spool
Cleaning
Tape Path
Guide Bar
Cleaning Roller
Blue Card Cleaning Roller
Operator Maintenance
Take-Up Spool
Figure 5-3 Cleaning Tape Assembly
NBS Technologies Inc.
Side View
Retainer Knob
Retainer Plate
Retainer Plate
Retainer Knob
Chapter 5 Page 6