G Erase; Erase - Sharp AR-C260 Operation Manual

Erase

The erase function is used to erase the shadow lines on copies produced when copying thick originals or books. The
erase modes that can be selected are shown below. The erase width is approximately 1/2" (10 mm) in it's initial
setting.
Original
1 Touch the [ERASE] key on the SPECIAL
MODES screen.
ERASE
Y
COVERS
2 Select the desired erase mode.
EDGE ERASE
EDGE CENTER EDGE+CENTER
3 Adjust the amount of erase and touch the
[OK] key.
CANCEL OK
EDGE
(0 1)
1/2
inch
Copy
The erase setting screen
will appear.
The erase icon ( ) will
also appear in the upper
left of the screen to
CO
indicate that the function
AD
is turned on.
Select one of the three
erase modes. The
selected key will be
highlighted.
Use the and keys
to adjust the erase width
and then touch the [OK]
key.
EDGE ERASE
Eliminates shadow lines around the edges of
copies caused when heavy paper or a book is used
as an original.
CENTER ERASE
Eliminates shadow lines produced by the bindings
of bound documents.
EDGE + CENTER ERASE
Eliminates shadow lines around the edges of
copies and eliminates the shadow at the center of
copies.
4 Touch the [OK] key on the SPECIAL
MODES screen.
Return to the main screen of copy mode.
About the steps that follow
If a reversing automatic document feeder is
being used, see pages 5-2 through 5-6. If the
document glass is being used, see pages 5-7
through 5-9.
To cancel the erase function, touch the [CANCEL]
key on the erase setting screen.
SPECIAL MODES
6
6-5