Reduction/Enlargement/Zoom; G Automatic Selection (Auto Image); Automatic Selection (Auto Image) - Sharp AR-C260 Operation Manual

REDUCTION/ENLARGEMENT/ZOOM

Reduction and enlargement ratios can be selected either automatically or manually as described in this section.

Automatic selection (auto image)

The reduction or enlargement ratio will be selected automatically based on the original size and the selected paper size.
1 Place the original in the document feeder
tray (when a
document feeder is installed) or on the
document glass. (page 4-6)
The detected original size will be displayed.
NOTE
Automatic ratio adjustment can only be used for the
following original and paper sizes. It cannot be used
for other sizes. However, in the case of non-standard
original and paper sizes, the sizes can be entered to
make automatic ratio adjustment possible for those
sizes. (page 6-24)
Original sizes:11" x 17", 8-1/2" x 14", 8-1/2" x 11", 8-
1/2" x 11"R, 5-1/2" x 8-1/2" (A3, B4,
A4, A4R, B5, B5R, A5)
Paper size: 11" x 17", 8-1/2" x 14", 8-1/2" x 13", 8-1/
2" x 11", 8-1/2" x 11"R, 5-1/2" x 8-1/2",
(A3, B4, A4, A4R, B5, A5)
Touch the [PAPER SELECT] key and then
2
select the desired paper size.
1. 8½x11 RECYCLED
2. 11x17
PLAIN
3. 8½x14
PLAIN
NOTE
If paper of the desired size is not loaded in any tray,
load paper of the required size in a paper tray or the
bypass tray.
Touch the [AUTO IMAGE] key.
3
PAPER
X
COPY
AUTO IMAGE
5-12
reversing automatic
When touching the
desired paper size
selection key, the
selected key will be
highlighted and the
paper selection screen
will close.
1
0
ORIGINAL 8½x11 AUTO
EXPOSURE
PLAIN
11x17
8½x11
PAPER SELECT
8½x11
129
%
DUPLEX
11x17
COPY RATIO
8½x14 AUTO IMAGE
NOTE
If the message "ROTATE ORIGINAL FROM
" is displayed, change the orientation of the
original as indicated in the message. When the
message above is displayed, copying can be done
without changing the orientation, but the image will
not fit the paper correctly.
4 Use the numeric keys to set the desired
number of copies.
Use the [C] (clear) key to cancel an entry if a mistake
has been made.
Press the [COLOR COPY START (
5
or [BLACK COPY START (
To cancel the auto image mode, touch the [AUTO
IMAGE] key again to clear the highlighted display.
(Step 3)
The [AUTO IMAGE] key
will be highlighted and
the best reduction or
enlargement ratio for the
original size and the
selected paper size will
be selected and
displayed in the copy
ratio display.
TO
Up to 999 can be set.
If you are only making a
single copy, the copy
can be made with the
copy number display
showing "0".
)]
)] key.
If you placed the original
on the document glass,
set the output to "Sort",
and pressed the [BLACK
COPY START] key, you
must touch the [READ-
END] key after all pages
of the original have been
scanned. (Step 7 on
page 5-8)