Erase Copy - Sharp MX-M260 Operation Manual

ERASE COPY

The erase function is used to erase the shadow lines on copies that are produced when copying thick originals or
books. The erase modes that can be selected are shown below. The erase width is initially set to 10 mm (1/2").
1
Touch the [ERASE] key in the special
modes screen.
FT ERASE
JOB
PY
BUILD
2
Select the desired erase mode.
ERASE
CENTRE EDGE+CENTRE
EDGE
ERASE
ERASE
3
Adjust the erase width as needed and
touch the [OK] key.
CANCEL
EDGE
(0 20)
10
mm
Downloaded From ManualsPrinter.com Manuals
The erase setting screen
will appear.
The erase icon (
will also appear in the
screen to indicate that
MU
the function is turned on.
Select one of the three
erase modes. The
ERASE
selected key will be
highlighted.
Use the and
OK
to adjust the erase width.
The erase width can be
set from 0 mm to 20 mm
increments of 1 mm (0"
to 1" in increments of
1/8").
EDGE ERASE
Eliminates shadow lines around the edges of copies
caused when heavy paper or a book is copied.
CENTRE ERASE
Eliminates shadow lines produced by the bindings of
bound documents.
EDGE + CENTRE ERASE
Eliminates both the shadow lines around the edges of
copies and the shadow at the centre.
4
Touch the [OK] key in the special
modes screen.
You will return to the main screen of copy mode.
, etc.)
About the steps that follow
If the document glass is being used, see page 23.
If the RSPF is being used, see page 24.
• This feature cannot be used with
Note
• This feature cannot be selected when
• To cancel the erase copy function, touch the
keys
CONVENIENT COPY FUNCTIONS
non-standard size originals.
mixed feeding (p.26) is used.
[CANCEL] key in the erase setting screen.
(See the screen of step 3.)
3
43