Loading Paper; G Loading Paper In Paper Tray 1; G Changing The Paper Size In Paper Tray 1; Loading Paper In Paper Tray 1 - Sharp AR-C260 Operation Manual

LOADING PAPER

The message "ADD PAPER" or "OPEN TRAY AND ADD PAPER" will appear when paper runs out during operation.
Follow the procedure below to load paper.
NOTES
G Do not use curled or folded paper. Doing so may cause a misfeed.
G For best results use paper supplied by SHARP. (See pages 2-9, 2-17.)
G When you change the paper type and size in paper tray 1, you must change the paper type and size settings as
explained in "Setting the paper type" (page 2-11).
G Do not place heavy objects or press hard on any tray which is pulled out.

Loading paper in paper tray 1

1 Pull out paper tray 1.
2 Load paper into the tray.

Changing the paper size in paper tray 1

The following paper size settings are available for paper tray1: 8-1/2" x 11", A4, B5, and "EXTRA"*
procedure to change the size as needed.
1
* This is limited to square or rectangular paper, 11" x 17" to 8-1/2" x 5-1/2" (A3 to A5) size.
1 Pull out paper tray 1.
If paper remains in the tray, remove it.
2 Adjust the paper size slide to the paper
size.
"EXTRA" to inform the machine that a special size
paper has been loaded. (When AB-based size
paper is loaded, move the size slide to "EXTRA".)
2-2
Gently pull the tray out
until it stops.
Load a stack of paper no
higher than the indicator
line (about 500 sheets of
the recommended paper
for color (20 lbs. or 80 g/
2
m ), or approximately
500 sheets of SHARP
standard paper (20 lbs.
or 80 g/m 2 )).
Move the paper size
slide right or left to
indicate the paper size
being loaded.
If a special size paper is
loaded in the paper tray,
set the size slide to
3 Gently push tray 1 into the machine.
Push the tray firmly all the way into the machine.
4 Set the paper type.
If you change the paper type, be sure to set the
paper type refer to "Setting the paper type" (page
2-11).
NOTE
If you load a different size of the same type of paper,
you only need to change the position of the size slide
(see step 2 below); you do not need to change the
paper type.
5 Loading paper in paper tray 1 is now
complete.
Note that setting the size slide to "EXTRA" only
informs the machine that a special size of paper
has been loaded; it does not inform the machine of
the specific size. If you wish to inform the machine
of the specific size, follow the steps in "Setting the
paper size when an extra size is loaded" (page 2-
11). (If you do not set a size, part or all of the image
may not print.)
3 Adjust the guide plates A and B by
squeezing their lock levers and sliding
them to the paper size to be loaded.
1 . Use the following
The guide plates A and
B are slidable. Adjust
them to the paper size to
be loaded while
squeezing their lock
levers.