Troubleshooting Saddle Stitch Finisher Problems - Sharp AR-C260 Operation Manual

SADDLE STITCH FINISHER

Troubleshooting saddle stitch finisher problems

Check the list below before calling for service.
Problem
Stapling position is
not correct
Stapling position not set properly?
(including saddle
stitch).
Are any saddle stitch finisher covers open? Close all covers. (See page 3-10 and 3-11.)
The saddle stitch
finisher does not
Message indicating need to remove paper
operate.
from the stapler compiler displayed?
Message
displayed?
Message to add staples displayed?
Stapling cannot be
performed (including
Different size paper included?
saddle stitch).
Is the paper badly curled, preventing
stapling?
The punch hole
The punch function is not set to the correct
positions are not
punch positions.
correct*
1
Message to check the punch module
displayed?
Mixed paper sizes?
Cannot be punched.*
Paper is badly curled and the output paper
is not punched.
* When a hole punch module is installed
3-12
Check
to check the staple
Solution or cause
Check the stapling position setting. (See
pages 3-4, 3-13 and 3-14.)
Remove all remaining paper from the stapler
compiler referring to step 4 on page 3-8.
unit
Remove jammed staples. (See page 3-8.)
Replace the staple cartridge. (See page 3-7.)
Check that a staple cartridge has been
installed. (See page 3-7.)
Stapling cannot be performed onto different
size paper.
Differences in paper quality and type may
result in bad curling of output paper. Take the
paper out of the tray or bypass tray, turn it
around, and reload it so that the top and
bottom edges are reversed.
Check the allowed hole punch positions. (See
page 3-5.)
Dispose of punch scraps. (See page 3-9.)
Punching is not possible when different paper
sizes are mixed together.
Differences in paper quality and type may
result in bad curling of output paper. Take the
paper out of the tray or bypass tray, turn it
around, and reload it so that the top and
bottom edges are reversed.